Dreame L10s Ultra Gen3

How can I add more areas for the robot to clean?

Do you mean on the same floor? Or multiple floors? If you mean the same floor make sure all room doors are open and send the robot out to map again. It should then find all the rooms while it’s maps. If you mean of multiple floors, click on the map editor, select floors and change it from single to multiple. To do multiple floors is a bit more difficult. First take the robot to the next floor (leave the dock downstairs plugged in) place the robot on the new floor. The place you put it down will be where it thinks it’s supposed to start and end. Run the quick mapping. Once done give this map a name eg “ landing, first floor, second floor” if you just want it to vacuum you then put the robot on that floor close to where you originally had it. Make sure on your map editor management you have selected the new floor and run a vacuum program. Robot might spin in circles a few times as it works out where it is. It will then vac the floor level or rooms depending on what you have chosen it to do. Getting it to mop that floor is a little more work as you first have to return the robot to the dock to wash the mop pads and exit the dock. Then carry it back to the correct floor, select the correct map and choose mop only or vac and mop. Once it’s done, carry the robot back downstairs to the dock, place near the dock, select the right map again from the map editor, and either press the button on the robot to return to the dock or select from the app to “END” this should then make it self clean and charge back up depending on your model robot.

Hello,

Do you mean adding more rooms to be cleaned?

If the rooms are on the same floor, simply open the room doors and start a full-home cleaning task. The robot will automatically enter the new rooms and update the map accordingly.

If the rooms are on a different floor, you can follow Richard's suggestion to create and save a new map for that floor.😊