Exciting Update: Discover Your Local Dreame Forum! |
|
|
|
|
|
|
|
|
|
|
|
|
|
1. Please check whether the Auto Detergent Dispensing function is enabled. If it is disabled, enable it and run a mop washing cycle. After washing, gently shake the dirty water tank and check whether foam is present. If foam is visible, this indicates that the base station has successfully dispensed detergent automatically. 2. We recommend removing the detergent cartridge and shaking it firmly several times while it still contains detergent. If liquid flows out from the marked outlet at the bottom of the cartridge, it indicates that the detergent dispensing system is functioning properly. Thank you for your understanding.
6-11-2026 07:43
Hello, The detergent consumption during a single mop wash cycle is approximately 1.33 mL, and about 0.67 mL during a rewash cycle. On average, after around 100 mop-washing cycles, approximately one-third of the detergent compartment will be consumed. Therefore, the amount of detergent used each time is relatively small, and a visible drop in the detergent level may not be obvious to the naked eye. If you are certain that the detergent level has not changed at all, or that the device is not dispensing detergent, please follow the steps below:
6-11-2026 07:42
|
|
© 2026 Dreame Forum All Rights Reserved | Support by Discuz! X5.0 Font by MiSans