I received the new Dreame X50 Ultra firmware version 4.3.9_2044 yesterday, but there were no details provided about what's changed, added, or fixed. Could you please share the full update information? Thanks!
I exactly wanted to learn what are those fixed known issues, could you please share details?
Here are my initial impressions of the Dreame X50 Ultra Complete:
Issues:
- During the initial mapping, although the house looked fine while scanning, the map rotated around 45% and became skewed as soon as it divided the rooms at the end. I tried this process several times, but the result didn’t change. Finally, I closed off the room at the far end, changed the location of the station, and after that it mapped correctly. Then I put the station back in its original place and forced the robot to find it. It added the room in the next cleaning session and I manually divided it. It seems to be working properly for now with this method.
- On average, it consumes about 1% battery for every 1 minute or 1 square meter.
- Sometimes it stops in the middle of a carpet or on the floor and does strange movements, spinning around itself several times before continuing.
- When returning to the station, it doesn't take the shortest route; it tries to go under chairs and such.
- In the first mopping attempt, although it recognized the carpet and lifted its mops, it roamed around the entire carpet as if it was cleaning it, but the mops didn’t spin.
- Not using side brush or mop extend in every corners or needed areas.
Pros:
- If it can navigate properly, the vacuuming and mopping performance is excellent.
- There’s absolutely no issue with hair tangling.
Questions:
- Have these issues been resolved with the latest firmware update?
- After installing a new firmware version, is it necessary to reset the device or remap the house?
What’s the exact model of your vacuum robot, and which firmware version is it currently running?
I bought the Dreame X50 Ultra Complete six days ago. It came with version 4.3.9_1812, then prompted an update to 4.3.9_1911 during the initial setup, and just yesterday, I received version 4.3.9_2044.
